PDFJadoo › Blog › UPSC Upload Guide

UPSC upload guide: photo, signature and document rules that refuse files

UPSC adds a twist most portals do not have: a supporting document can be the perfect size, in the perfect format, and still be refused because its file name is not the exact name prescribed. Add a signature that is really three signatures and a photograph ruled by what fills the frame, and you have the full set of traps — each one avoidable.

Free, in your browserFiles never uploadedRules from UPSC instructions
PDFJadoo logoBy the PDFJadoo Team9 min read
UPSC document files being renamed to their exact prescribed names and measured against size limits while the PDFJadoo genie checks a three-signature image
Size, format — and the name on the file. UPSC checks all three.

The complete rule set, before the detail

Every figure and condition in this guide comes from UPSC's own official material — the “Instructions for uploading documents” and the photo and signature instruction PDF, both published through upsconline.nic.in and linked in full at the end of this page. Lay the whole set out first, because UPSC uploads fail one rule at a time and it helps to see all of them at once.

UploadFormatSize and dimensionsThe rule people miss
Supporting documentsPDF50–300 KB eachEach file must carry the exact file name UPSC prescribes — wrong name means refused
PhotographJPG20–200 KBThe face must cover at least 75% of the frame
Photo IDJPG20–200 KBIt is its own upload, with its own window
SignatureJPG20–100 KB; 350–500 px wideThree signatures, one below another, inside a single image

Read the last column as the theme of this guide. UPSC's refusals are rarely about effort or quality; they are about exactness — an exact name, an exact count of signatures, an exact proportion of the frame. The good news inside that strictness is that every rule is published in advance. Nothing here needs to be guessed, and a candidate who prepares against the written instructions, rather than against habit from other portals, will meet a form that simply accepts the files. If you have already met a refusal, our troubleshooting companion — UPSC uploads rejected: size, format, name — works the problem from the error backwards.

Supporting documents: PDF, 50–300 KB — and the exact prescribed name

Each supporting document must be a PDF, and each must fall between 50 and 300 KB. Note the floor once more: a document compressed beneath 50 KB is outside the specification just as one above 300 KB is, so documents should be prepared into the window, not simply made as small as possible. Scanned certificates and mark sheets do not naturally arrive as PDFs of the right weight, which is where the preparation tools come in: JPG to PDF turns page images into a proper PDF document, and Compress PDF brings an overweight PDF down toward the window — checking, after each step, the size of the file that actually resulted.

Then comes the rule that defines UPSC uploads. Every document must be saved with the exact file name UPSC prescribes for it in the official instructions. Not a similar name, not a clearer name of your own invention — the prescribed one, character for character. A wrongly named file is refused even when everything else about it is correct, and because the refusal can look like a generic upload failure, candidates waste hours re-compressing a file whose only fault sits in its name. Work in the safe order: prepare the document to size first, rename it to the prescribed name as the final step, then verify the name once more, slowly, against the instructions before uploading. Keep the renamed files together and do not let your computer's helpful duplicate-numbering rename them again on the way — a quiet “(1)” appended by a downloads folder is still a wrong name.

The photograph: JPG, 20–200 KB, with the face filling the frame

The photograph must be a JPG between 20 and 200 KB — a comfortably wide window by portal standards. Its distinctive rule is not about the file at all: your face must cover at least 75 percent of the frame. That is a content rule, governing the photograph itself, and it changes how you should choose the image. A distant portrait with generous headroom, however professional it looks, puts a small face in a large frame and fails the proportion test. Choose or take a photograph composed for this purpose, with the face genuinely filling the frame as the instruction requires, and only then prepare its file to the format and window — our Passport Photo tool handles that file preparation in your browser, where files are never uploaded to a server.

The honest limit deserves its usual plain statement: a tool can resize and re-weigh a compliant photograph perfectly; it cannot promote a non-compliant one. If the only photograph you have shows a small face in a wide scene, the fix is a new photograph taken to the instruction, after which the file step takes moments. Candidates sometimes discover this rule at the upload screen, with the deadline doing its usual work; discovering it here, in a guide, is the cheaper way.

The photo ID: JPG, 20–200 KB, its own upload

The photo ID is a separate upload with its own specification: a JPG between 20 and 200 KB. Its simplicity is its trap — because it shares its window with the photograph, it is easy to assume one preparation method, one folder or even one file covers both. It does not. The photograph and the photo ID are two different images of two different things, each uploaded in its own place, each measured against the same window independently. Prepare the ID image on its own: a clean, legible capture of the document, prepared to JPG and weighed after preparation, exactly as you verified the photograph. Legibility carries the same weight here as with any official document — an ID that cannot be read clearly has failed in substance whatever its file properties say, so check the prepared image at full size and confirm every detail reads before it goes in.

The signature: three signatures, one image, 20–100 KB, 350–500 px wide

UPSC's signature instruction is the most distinctive in this guide, and the one most often prepared wrongly by candidates following other portals' habits. The upload is a single JPG image containing three signatures, one below another — three specimens of your signature, signed in a vertical column on one sheet, captured as one image. The file must be between 20 and 100 KB, and the image must be 350 to 500 pixels wide. Three separate signature files do not satisfy the instruction, however perfect each one is; the three-in-one arrangement is itself the requirement.

Preparation follows naturally once the arrangement is understood. Sign three times down a clean sheet, in your ordinary hand and at your ordinary size, leaving the column tidy. Capture the sheet straight and evenly lit, then prepare the single image: JPG format, width inside the stated pixel range, file size inside its window. Verify all three measurements on the finished file — format, width and weight — because this upload, uniquely here, is judged on all of them together. Then, for the photograph side of the same discipline, our general guide to why photos are rejected is worth a read before you begin the form.

Prepare the photo and documents in your browser

Photo sizing, JPG conversion and PDF compression all run in your browser on PDFJadoo — your files are never uploaded to a server, which is the right way to handle identity documents and certificates. Prepare each file, verify it against the table, rename the documents exactly, then apply.

Prepare my photograph Compress a document

A preparation order that respects every rule

Begin with the official instructions open beside you — the two UPSC documents linked below — because the prescribed file names live there and nowhere else. First, prepare the supporting documents: build each as a PDF, bring each into the 50 to 300 KB window, and rename each with its exact prescribed name as the last step before filing them together. Second, settle the photograph: a frame-filling image first, its JPG file inside 20 to 200 KB second. Third, prepare the photo ID image on its own, to the same window, and read it back at full size. Fourth, make the signature sheet — three signatures, one below another — and prepare that single image to its size window and its pixel width. Finally, walk the finished set once against the checklist below, names included, before the form is opened. Files prepared in this order fail for interesting reasons rarely and for the classic reasons — wrong name, wrong count, wrong window — essentially never.

UPSC's rules are exacting, but they are also exact — published, measurable and satisfiable in full before the application begins. Meet them on paper first, and the upload screen becomes what it should be: a formality between you and the examination.

Fair questions

Why did UPSC refuse a document that was the right size?

A likely cause is the file name. UPSC requires supporting documents to be saved with the exact file names it prescribes, and a document with the wrong name is refused even when its size and format are correct. Rename the file to the prescribed name exactly as given in the official instructions, and upload it again.

How many signatures does the UPSC signature upload need?

Three. The signature upload is a single JPG image containing three signatures, one below another, with a file size of 20 to 100 KB and an image width of 350 to 500 pixels. Sign three times on one sheet, in a vertical column, and prepare that one image — three separate files do not meet the instruction.

What size must the UPSC photograph and photo ID be?

Both the photograph and the photo ID are JPG files of 20 to 200 KB. The photograph carries an additional content rule: your face must cover at least 75 percent of the frame. A file can measure correctly and still fail that rule, because it governs what the photograph shows, not just the file carrying it.

What are the rules for UPSC supporting documents?

Each supporting document must be a PDF between 50 and 300 KB, and it must be saved with the exact file name UPSC prescribes for that document. Check both conditions for every document: a PDF of the right size with the wrong name is refused, and so is a correctly named file outside the size window.

Can a tool fix a photograph where my face is too small in the frame?

No. The requirement that the face cover at least 75 percent of the frame is a rule about the photograph itself. A tool can prepare a compliant photograph to the right format and file size, but it cannot turn a distant, small-face photograph into a compliant one. Take or choose a photograph that follows the rule, then prepare its file.

Are my documents uploaded to a server when I prepare them here?

No. PDFJadoo tools run in your browser, and your files are never uploaded to a server. Resizing, converting and compressing your photograph, signature image and documents all happen on your own device.

Sources: UPSC, “Instructions for uploading documents” (official PDF via the UPSC candidates portal): upsconline.nic.in — Instructions for uploading documents; and UPSC, photo and signature upload instructions (official PDF): upsconline.nic.in — instruction-photo-signature-upload-upsc.pdf. Instructions are issued per examination — always follow the documents attached to your own application. PDFJadoo is not affiliated with UPSC.

Keep reading